Table of Contents
Advertisement
Preparing for installation
Handling
(cont.)
4.
Fig. 6
3. Pull out plug
from the power supply.
sYS
Note
The electrical cable with plug designation
not required.
4. Use a dismantling aid, e.g. two-armed puller, to
remove the motor with torque support.
Note
Motor dimensions:
■
Width = 100 mm
■
Depth = 84 mm (incl. flange plate)
■
Shaft diameter = 20 mm
14
7.
6.
5.
5. Lift out the feather key.
6. Remove chain tensioner.
is
s:G
7. Remove chain by opening the master link.
3.
Advertisement
Table of Contents
