Mitsubishi MELESEC-ST User Manual page 21

Term
Slice No.
Slice position No.
Start slice No.
Command
Command parameter
ST bus cycle time
A - 19
The number assigned to every 2 occupied I/O points of each module.
The numbers are assigned in ascending order, starting from "0" of the head module. (The
maximum value is 127.)
This is used for specifying a command execution target.
The number that shows where the slice module is physically installed.
The numbers are assigned in ascending order, starting from "0" of the head module. (The
maximum value is 63.)
This is used for specifying a command execution target.
The start slice No. assigned to the head module and slice modules.
Generic term for requests that are executed by the master station for reading each module's
operation status, setting intelligent function module command parameters or various controls.
Generic term for parameter set in commands or GX Configurator-ST.
All of the parameters set for the head module and slice modules are command parameters.
Processing time for the head module to refresh the input or output status of each slice module.
Definition
A - 19