Mitsubishi MELESEC-ST User Manual page 98

10 MOUNTING AND INSTALLATION
Wiring marker color
Black Signal wire
Red DC power supply (+24V; +5V)
Blue -, 0V, N
Red-Blue System power supply
Yellow-Green FG
Green Shield
Brown L1 phase
10 - 6
(b) According to the wiring of the slice module, push the wiring markers into the
bottom recesses of the terminal block. The following table indicates an
example of the color codes corresponding to the wire types.
Wire type
(4) Mounting the end bracket and end plate
(a) End bracket (left side)
Mount the end bracket to the
DIN rail on the left side of the
base module.
The following table indicates an
example of the color codes
corresponding to the wire
types.
Tighten the screw at the end
bracket top with a screwdriver.
Make sure that the end bracket
is securely fixed to the DIN rail.
Complete
MELSEC-ST
Wiring marker
Base module
1
End bracket
DIN rail
For mounting, removing and wiring, use the
screwdriver recommended in Appendix 4 or
equivalent.
10 - 6