Mitsubishi MELESEC-ST User Manual page 99

10 MOUNTING AND INSTALLATION
10 - 7
(b) End plate (right side: including end bracket)
Mount the end bracket into the
recess of the end plate.
Install the end plate (including
the end bracket) on the DIN
rail.
Slide the end plate (including
the end bracket) to the left
side module until it makes
intimate contact with that
module, and then tighten the
end bracket screw through the
hole in the end plate top.
Make sure that the end plate
(including the end bracket)
and each module are securely
fixed to the DIN rail.
Complete
POINT
Mount the end plate (including the end bracket) to the DIN rail after loosening the
end bracket screw.
MELSEC-ST
End plate
Recess
End plate
(including end bracket)
For mounting, removing and wiring, use the
screwdriver recommended in Appendix 4 or
equivalent.
End bracket
1
DIN rail
10 - 7