Removing The Modules - Mitsubishi MELESEC-ST User Manual

10 MOUNTING AND INSTALLATION

10.3 Removing the Modules

10 - 11
This section explains how to remove the head module, slice modules, end bracket, end
plate, etc.
(1) Removing the slice modules
Push the hooks at both ends of the slice module had with your fingers, and pull
the slice module away from the base module in the direction of arrow. Dismount
the second and later slice modules in the same manner.
Slice module
Base module
POINT
Remove the wiring after removing the slice modules from the base modules.
(2) Removing the end bracket and end plate
Insert a screwdriver into the
end plate, and loosen the end
bracket screw.
Slide the end plate and end
bracket to the right to move
them away frm the left side
base module.
Further loosen the end bracket
screw, and remove the end
bracket and end plate from the
DIN rail.
Complete
MELSEC-ST
Hooks
DIN rail
End plate
(including end bracket)
DIN rail
For mounting, removing and wiring, use the
screwdriver recommended in Appendix 4 or
equivalent.
1
10 - 11