Siemens NXPLUS C Installation And Operating Instructions Manual page 19

Conformity of voltage
transformers
806-9004.9 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C • Revision 02
The voltage transformer can be used as measuring transformer.
The approval symbol for the voltage transformer is located on the type plate.
The approval symbol is valid throughout the entire service life of the voltage transformer.
Observe deviating country-specific statutory regulations, if applicable.
For an inspection by a calibration office or an officially recognized inspecting authority,
the test adapter (802-8061.3) shown below can be installed on voltage transformer 4MT3.
Fig. 12: Installing the test adapter on
voltage transformer 4MT3
The test adapter can be procured from the regional Siemens representative.
Description
① Secondary lead
② Connection of measuring
equipment
19/266