Siemens NXPLUS C Installation And Operating Instructions Manual page 151

Installing the transformer
806-9004.9 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C • Revision 02
Remedy: Undo the cable clamps and pull the cables to the front until the black marking is
completely visible.
➭ Remove the cross member down at the panel.
➭ Set the transformer ① down on the rails ③ . Roll the transformer into the panel as far as it
will go ② .
➭ Push the cross member between the base plate and the rails. After this, fasten the cross
member with 4 bolts.
Installation
151/266