Trouble Shooting - H&S TWM9 Operator's Manual

Table of Contents

Advertisement

WARNING:
MAKE SURE THAT THE TRACTOR IS SHUT OFF AND THE MERGER CAN NOT
MOVE BEFORE SERVICING THE TWIN MERGER. MAINTENANCE AND REPAIR
SERVICE WORK TO BE PERFORMED BY A QUALIFIED SERVICE PERSON ONLY.
TROUBLE...
Merger Will Not Swing Into
Field or Transport Position
Merger Pickup Heads Will
Not Raise Or Lower
Merger Pick Or Cross
Conveyor Will Not Run
Cross Conveyor Will
Not Run

TROUBLE SHOOTING

POSSIBLE CAUSE...
Transport Lock Pin Still
Engaged
Hydraulic Hoses Not Connected
To Tractor Remotes
Hydraulic Hoses Mixed Up With
Pickup Lift Hoses
Hydraulic Hoses Not Connected
To Tractor Remotes Outlets
Hydraulic Hoses Mixed Up With
Merger Swing Cylinder Circuit
Pickup Transport Locks Still
Engaged
No Power To Control Box
Control Box Not Plugged Into
Merger Main Harness
PTO Shaft Not Connected To
Tractor
PTO Not Turning
Suction Ball Valve Turned Off
System Relief Valve Sticking
Switches On Control Box
In Neutral Position
Control Box Not Properly
Connected To Tractor Or
Wire Harness
-32-
POSSIBLE REMEDY...
Remove Transport Lock Pin
Connect Hoses To Tractor Remote
Outlets
Sort Hydraulic Hoses Correctly And
Re-Couple To Tractor Remote
Outlets
Connect Hoses To Tractor Remote
Outlets
Sort Hydraulic Hoses Correctly And
Re-Couple To Tractor Remote
Outlets
Rotate Transport Lock Valves
Check Tractor 7-Pin Connector For
Power
Plug Control Box Wiring Harness
Into Main Harness
Connect PTO Shaft To Tractor
Engage Tractor PTO
Turn Ball Valve At The Front Of The
Merger Tongue
Contact Your Dealer For Proper
Testing
Move Toggle Switch To Right
or Left
Properly Connect Control Box Plugs

Advertisement

Table of Contents
loading

This manual is also suitable for:

Twm12

Table of Contents