Table of Contents
Advertisement
Installation
2.2 INSTALLING THE 7C03 MMAC SMARTSWITCH
Prior to installing the 7C03 MMAC SmartSwitch, please read the
note that appears on page 2-1.
To install the 7C03 MMAC SmartSwitch in an MMAC-M5FNB or
MMAC-M8FNB chassis, use the following steps and refer to
Figure 2-1.
1. Remove the blank panels covering the slots in which the 7C03
MMAC SmartSwitch will be installed. All other unused slots
must remain covered to ensure proper air flow and cooling.
2. Hold the 7C03 MMAC SmartSwitch by the top and bottom
handles and align the plastic rails on the top and bottom of the
7C03 MMAC SmartSwitch with the corresponding card guides
on the MMAC chassis.
3. Slide the 7C03 MMAC SmartSwitch straight into the chassis
until the 7C03 engages the backplane connectors.
4. Tighten the top and bottom thumb screws on the 7C03 MMAC
SmartSwitch.
5. You can now install the 7X00 Module and SmartSwitch
interface modules into the 7C03 MMAC SmartSwitch. Refer to
the applicable module user's guide for detailed installation
instructions.
2-2
Advertisement
Table of Contents
