Chapter 2 Installation; Unpacking The 7C03 Mmac Smartswitch - Cabletron Systems 7C03 MMAC SmartSWITCH Installation Manual

Cabletron systems installation guide smartswitch 7c03 mmac

Hide thumbs Also See for 7C03 MMAC SmartSWITCH:

Table of Contents

This chapter contains instructions for unpacking and installing the

7C03 MMAC SmartSwitch in an MMAC chassis. The 7C03 MMAC

SmartSwitch can be installed in an MMAC-M5FNB or in an

MMAC-M8FNB chassis.

Because of the modular nature of the power supplies and interface

Note:

modules in the MMAC-M5FNB and MMAC-M8FNB chassis,

there is no one standard MMAC configuration that can be used as

a reference. The way you configure your MMAC-M5FNB or

MMAC-M8FNB chassis (number of power supplies, number and

types of interface and management modules) is determined by

your specific needs. Therefore, to insure that the power

requirements of your MMAC will not be exceeded by the addition

of a 7C03 MMAC SmartSwitch, we recommend that you contact

Cabletron Technical Support prior to installing the 7C03 MMAC

SmartSwitch.

Unpack the 7C03 MMAC SmartSwitch by using the following

steps:

1. Remove the 7C03 MMAC SmartSwitch from the shipping box.

(Save the box and packing materials in the event the 7C03

MMAC SmartSwitch must be reshipped.)

2. Remove the 7C03 MMAC SmartSwitch from the plastic bag.

3. Examine the 7C03 MMAC SmartSwitch and check for damage.

If damage exists, DO NOT install the 7C03 MMAC

SmartSwitch; contact Cabletron Systems Technical Support.

Otherwise, install the 7C03 (see Section 2.2).

CHAPTER 2

INSTALLATION

2-1

Table of Contents