Table of Contents
Advertisement
Figure 31. Installing a memory module
Next steps
1. Follow the procedure listed in
2. To verify if the memory module has been installed properly, press F2 and go to System Setup Main Menu > System BIOS
> Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of the
installed memory.
3. If the System Memory Size is incorrect, one or more of the memory modules may not be installed properly. Ensure that the
memory modules are firmly seated in their sockets.
4. Run the system memory test in system diagnostics.
Cooling fans
Removing a cooling fan
Prerequisites
CAUTION:
Do not remove or install the fan by holding the blades.
CAUTION:
Never operate your system with the system fan removed. System can overheat and result in
shutdown of the system and loss of data.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Disconnect the fan power cable from the system board connector.
2. Stretch the grommets securing the fan to the system.
3. Hold the fan by the sides, and slide it from the grommet.
4. Repeat steps 2 and 3 to release the fan from the remaining grommets.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
43
Advertisement
Table of Contents
