Table of Contents
Advertisement
NOTE:
The procedure to remove the BOSS S1 card is similar to the removing an expansion card.
Steps
1. Align the M.2 SSD module at an angle with the BOSS S1 card connector.
2. Insert the M.2 SSD module until it is firmly seated in the BOSS S1 card connector.
3. Using the Phillips 1 screwdriver, secure the M.2 SSD module on the BOSS S1 card with the screw.
Figure 42. Installing the M.2 SSD module
Next steps
1.
Install the BOSS S1 card
NOTE:
The procedure to install the BOSS S1 card is similar to installing an expansion card.
2. Follow the procedure listed in
Processor and heat sink
This is a service technician replaceable part only.
Removing the heat sink
Prerequisites
WARNING:
The heat sink may be hot to touch for some time after the system has been powered off. Allow the
heat sink to cool before removing it.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Disconnect the heat sink fan power cable connector from the connector on the system board.
2. Using a Phillips 2 screwdriver, loosen the screws on the heat sink in the order that is mentioned below:
52
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
