Installing A 2.5-Inch Drive Into The 3.5-Inch Drive Adapter - Dell EMC PowerEdge T150 Installation And Service Manual

NOTE: If the 2.5-inch drive has Torx screw, use Torx 6 screwdriver to remove the drive from a 3.5-inch drive adapter.
2. Remove the drive from the 3.5-inch drive adapter.
Figure 16. Removing a 2.5-inch drive from the 3.5-inch drive adapter
Next steps
Replace a 2.5-inch drive into the 3.5-inch drive

Installing a 2.5-inch drive into the 3.5-inch drive adapter

Prerequisites
Follow the safety guidelines listed in the
Steps
1. Align the screw holes on the 2.5-inch drive with the screw holes on the 3.5-inch drive adapter.
2. Using a Phillips 1 screwdriver, tighten the screws to secure the drive to the 3.5-inch drive adapter.
NOTE: If the 2.5-inch drive has Torx screw, use Torx 6 screwdriver to install the drive to a 3.5-inch drive adapter.
adapter.
Safety instructions.
Installing and removing system components 31