Table of Contents
Advertisement
Figure 50. Removing the system battery
CAUTION:
To prevent damage to the battery connector, you must firmly support the connector while
removing or installing a battery.
2. To install a new system battery:
a. Slide the battery with the positive side facing up under the securing tabs.
b. Press the battery into the connector until it snaps into place.
Figure 51. Installing the system battery
Next steps
1. Follow the procedure listed in
2. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
b. Enter the correct time and date in the System Setup Time and Date fields.
c. Exit the System Setup.
d. To test the newly installed battery, remove the system from the enclosure for at least an hour.
e. Reinstall the system into the enclosure after an hour.
After working inside your
system.
Installing and removing system components
59
Advertisement
Table of Contents
