Table of Contents
Advertisement
3.2.2
Installing the Cable Management Bar
To install the cable management bar, proceed as follows:
1.
Remove the cable management bar from the shipping box. Ensure that
there are four screws inside the bag with the cable management bar.
2.
Refer to
Figure
management bar with the two holes located underneath the 6C105,
near the front of the chassis.
3.
Using a Phillips screwdriver securely fasten the 4 screws.
Front Panel of Chassis
Figure 3-1 Installing the Cable Management Bar
6C105 Overview and Setup Guide
3-1. Line up the two holes on each side of the cable
Bottom of Chassis
Screws (4)
Setting Up the 6C105
Cable Management Bar
2016_05
3-3
Advertisement
Table of Contents
