Operator Controls And Indicators - Aritech 1X-X3E Series Operation Manual

BS 7273 user interface
For control panels configured for BS 7273, the labels for some interface buttons
change. See Table 2 below.
Table 2: Configured changes to interface buttons and LEDs
Item BS 7273 user interface
22 Auto/Manual mode and Only Manual mode button and LEDs
27 Extinguishing disabled switch LEDs

Operator controls and indicators

The following table gives an overview of the control panel operator controls and
indicators. Item numbers refer to Figure 1 on page 3.
Operational features described here may not be available to all users. Further
information on control panel operation and user restrictions can be found in
"Control panel operation" on page 18.
Table 3: Operator controls and LED indicators
Item Control/LED
1 Zone buttons and
LEDs (Z1, Z2, Z3)
2 Supply LED
3 General Fault LED
4 General Fire Alarm
LEDs
4
LED colour Description
Red/Yellow Disables or tests a zone (when pressed with the
General Disable or General Test button).
A red LED indicates a fire alarm in the
corresponding zone.
A flashing red LED indicates that the fire alarm
was activated by a detector. A steady red LED
indicates that the fire alarm was activated by a
manual call point.
A flashing yellow LED indicates a wiring fault in
the corresponding zone. A steady yellow LED
indicates a disablement or a test.
Green Indicates that the system is powered up.
Yellow Indicates a fault. The corresponding zone, device,
or function fault LED also activates.
Red Indicates a fire alarm.
Flashing red LEDs indicate that the fire alarm was
activated by a detector.
Steady red LEDs indicate that the fire alarm was
activated by a fire manual call point.
For alarms from fire detection zones, the
corresponding zone alarm LED indicates the
source or location of the fire alarm.
1X-X3E Series Operation Manual