Aritech 1X-X3E Series Operation Manual page 27

Testing sounders
To test the sounders, press the General Test button, and then press the Fire
Sounders Delay button.
Sounders can only be tested when the control panel is in standby state.
The test is indicated as follows:
• A steady General Test LED
• A steady yellow LED for the Fire Sounders Delay button
• The audible sounder test signal (3 seconds on, 5 seconds off) for the duration
of the test, without any configured delay
To end the test, press the General Test button, and then press the corresponding
sounder Fire Sounders Delay button again.
If there is an extinguishing preactivation, activation, release, or fire alarm event
during the test, the control panel exits the test and responds to the alarm event
as configured.
Disabling or enabling fire routing
To disable fire routing, press the General Disable button, and then press the Fire
Routing Start button.
The disablement is indicated as follows:
• A steady General Disable LED
• A steady yellow Fire Routing On LED
To enable fire routing, press the General Disable button, and then press the Fire
Routing On button again.
Note: Disabled fire routing does not operate or indicate a fault if there is a fire
alarm.
Disabling or enabling a fire routing delay
To disable a configured (and enabled) fire routing delay, press the Fire Routing
Delay button. To enable the delay, press the button again.
Testing fire routing
Note: Before performing any fire routing tests, ensure that the fire routing signals
are not connected or notify the fire brigade of the tests.
To test fire routing, press the General Test button, and then press the Fire
Routing Start button.
The test is indicated as follows:
• A steady General Test LED
• A steady yellow Fire Routing On LED
• A flashing Fire Routing On LED and the test signal (3 seconds on, 5 seconds
off) without any configured delay for the duration of the test
1X-X3E Series Operation Manual 23