Table of Contents
Advertisement
Post-Install
Setup
The Enterprise A8000 systems are designed with advanced internal programming,
which allows it to automatically adjust for a variety of conditions, including the added
functionality, alerts, and troubleshooting of an enhanced cloud management and
monitoring solution.
Once the AC power cable and antenna cables are connected, scan the QR code on
the Quick Registration Card to add the amplifier to your WilsonPro Cloud account. For
detailed instructions see the WilsonPro Cloud section.
Ethernet &
USB location
Input Power: 240V~, 0.5A, 50-60Hz
CAUTION: Double pole, neutral fusing. Disconnect power cable before servicing. WARNING: Power
cable must be plugged into an earthed socket outlet only. Verify the protective earthing connection of
the socket outlet at time of installation.
1
Remove here
8
power supply
The fuse mark on the switch indicates the fuse holders
2
behind the switch. The red/orange frame shows the
outline of the removable unit.
With a simple tool, the fuse holder unit (1) can be
removed from the filter. On the topside (2) behind
3
the switch there are two fuse holders for each live
connection. For fuse replacement, replace each with a
5x20mm, 0.5A, 250V time-lag fuse. On the bottom side
(3) is a clip to carry an additional spare fuse.
IN-BUILDING CELL SIGNAL AMPLIFIER
hand tighten ONLY
scan the QR code
for quick registration
ENTERPRISE A8000
Advertisement
Table of Contents
