Amplifier Installation Guide Dual-Band Direct Connection Amplifier with Contents: Guarantee and Warranty · · · · · · · · · · · · · · · · · · · · · · · · Before Getting Started / How it Works · · · · · · · · · · · · · · 3 Installing a Wilson Outside Antenna - In-Vehicle ·...
Page 2
Returned Material Authorization (RMA) number supplied by Wilson Electronics. Wilson shall, at its option, either repair or replace the product. Wilson Electronics will pay for delivery of the repaired or replaced product back to the original consumer.
Page 3
Installation Instructions for the Following Wilson Amplifiers Direct Connection Dual-Band Amplifier with GPS – Model # 2B1401 - Part #811200 Contains 1575 MHz bypass to allow for GPS reception. FCC ID: PWO2B1401SA IC: 4726A-2B1401SA The term “IC” before the radio certification number only signifies that Industry Canada technical specifications were met.
Before Getting Started This guide will help you properly install Wilson’s direct connection amplifiers in both in- vehicle and in-building applications. It is important to read through all of the installation steps for your particular application prior to installing any equipment. Read through the instructions, visualize where all the equipment will need to be installed and do a soft installation before mounting any equipment.
Page 5
In-Vehicle Installing a Wilson Outside Antenna To receive the best cell signal, select a location in the center of the vehicle’s roof at least 12 inches away from any other antennas and free of obstructions. Follow the specific antenna installation instructions included with the outside antenna (sold separately).
In-Vehicle Installing a Wilson Amplifier Select a location to install the amplifier that is away from excessive heat, direct sunlight, moisture and that has proper ventilation. Recommended installation locations for in-vehicle are: • Under the seat • In the trunk •...
In-Vehicle Installing a Wilson External Adapter An 18-inch external adapter is required to connect the cell phone or cellular data card to the amplifier. The external adapter is cell phone/data card-specific and may be purchased through a local retailer. Refer to Wilson’s Adapter Guide to identify the right adapter for your cell phone or cellular data card.
In-Building nstalling a Wilson Outside Antenna – In-Building Select a location on the roof of the building to install the outside antenna that has the most unobstructed line of sight to the cell tower. Follow the specific antenna installation instructions included with the outside antenna. Lightning protection is recommended for all in-building installations.
In-Building Installing a Wilson External Adapter An 18-inch external adapter is required to connect the cell phone or cellular data card to the amplifier. The external adapter is cell phone/data card-specific and may be purchased through a local retailer. Refer to Wilson’s Adapter Guide to identify the right adapter for your cell phone or Sample cellular data card.
Powering up a Wilson Amplifier Warning: Verify that both the outside antenna and the adapter extension cable are connected to the amplifier before powering up the amplifier. For in-vehicle, first connect the power cable to the amplifier input marked “DC 12 V IN” and then insert the large end into a 12 V DC power socket or cigarette lighter outlet.
Warnings and Recommendations Warning: Verify that both the outside antenna and the adapter extension cable are connected to the amplifier before powering up the amplifier. Warning: RF Safety: In-vehicle - The outside antenna must be installed with a separation of at least 20 inches from any of the vehicle’s occupants or nearby persons and must not be located or operating in conjunction with any other antenna or amplifier.
Amplifier Specifications Dual Band 800/1900 MHz Specifications Model Number / Part Number 2B1401 / 811200 Connectors FME-Male Impedance (input/output) 50 ohms Dimensions 5 x 3.5 x 1.2 inch or 12.7 x 8.9 x 3 cm Weight 1.03 lbs or 0.468 kg...