Figure 13: Ac Plug Types; Table 21: Ac Power Cord Specifications - Juniper EX2200 Complete Hardware Manual

Complete Hardware Guide for EX2200 Ethernet Switches

Table 21: AC Power Cord Specifications

Country/Region
Australia
China
Europe (except Italy, Switzerland, and
United Kingdom)
Italy
Japan
North America
Switzerland
United Kingdom
Related
Documentation
48
CAUTION: The AC power cord for each switch is intended for use with that
switch only and not for any other use.
NOTE: In North America, AC power cords must not exceed 4.5 meters
(approximately 14.75 feet) in length, to comply with National Electrical Code
(NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian Electrical
Code (CEC) Section 4-010(3). The cords supplied with the switch are in
compliance.
Table 21 on page 48 lists AC power cord specifications provided for each country or region.
Electrical Specifications
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
125 VAC, 12 A, 50 Hz or 60 Hz
125 VAC, 13 A, 60 Hz
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
Figure 13 on page 48 illustrates the plug on the power cord for each country or region
listed in Table 21 on page 48.

Figure 13: AC Plug Types

Power Supply in EX2200 Switches on page 14
General Safety Guidelines and Warnings for EX Series Switches on page 113
General Electrical Safety Guidelines and Warnings for EX Series Switches on page 141
Prevention of Electrostatic Discharge Damage on EX Series Switches on page 142
Plug Standards
AS/NZ 3112
GB2099 and GB1002
CEE (7) VII
CEI 23-16
JIS C8303
NEMA 5-15
SEV 1011 SEV 6534/2
BS 1363/A
Copyright © 2010, Juniper Networks, Inc.