Requirements For Mounting An Ex2200 Switch On A Desktop Or Wall; Clearance Requirements For Airflow And Hardware Maintenance For Ex2200; Switches; Figure 10: Clearance Requirements For Airflow And Hardware Maintenance For - Juniper EX2200 Complete Hardware Manual

Complete Hardware Guide for EX2200 Ethernet Switches

Requirements for Mounting an EX2200 Switch on a Desktop or Wall

Related
Documentation
Clearance Requirements for Airflow and Hardware Maintenance for EX2200 Switches
Clearance required
Front of chassis
42
You can install the switch on a desktop or wall. When choosing a location, allow at least
6 in. (15.2 cm) of clearance between the front and back of the chassis and adjacent
equipment or walls.
Ensure that the wall onto which the switch is installed is stable and securely supported.
If you are mounting the switch in sheetrock (wall board with a gypsum plaster core) or
in wall board not backed by wall studs, use hollow wall anchors capable of supporting
the combined weight of two fully loaded chassis. Insert the screws into wall studs
wherever possible to provide added support for the chassis.
Use the wall-mount kit from Juniper Networks to mount the switch on a wall. The
wall-mount kit is not part of the standard package and needs to be ordered separately.
Clearance Requirements for Airflow and Hardware Maintenance for EX2200 Switches
on page 42
Wall-Mounting Warnings for EX2200 Switches on page 134
Mounting an EX2200 Switch on a Desk or Other Level Surface on page 54
Mounting an EX2200 Switch on a Wall on page 61
When planning the site for installing an EX2200 switch, you must allow sufficient
clearance around the installed switch (see Figure 10 on page 42).
Figure 10: Clearance Requirements for Airflow and Hardware Maintenance
for EX2200 Switches
24" (61 cm)
for maintenance
17.5"
44.5 cm
Mounting bracket
The power cord retainer clips extend out of the rear of the chassis by 3 in.
Allow at least 6 in. (15.2 cm) of clearance on the side between devices that have fans
or blowers installed. Allow 2.8 in. (7 cm) between the side of the chassis and any
6" (15.2 cm)
6" (15.2 cm)
for airflow
Rear of chassis
10.5"
19"
(26.7 cm)
(48.2 cm)
6" (15.2 cm)
for airflow
Clearance
required for
maintenance
Copyright © 2010, Juniper Networks, Inc.