Ghost Controls DEP2 Installation And Owner's Manual page 62

P U S H - T O - O P E N
62
CANCELLING AUTOCLOSE TIME ON YOUR GATE
NOTE
Canceling AUTOCLOSE can only be performed when the gate opener is idle.
Cancelling AUTOCLOSE will remove your previous duration setting and force you to pick a new duration the next time
you enable AUTOCLOSE. You can use PartyMode
current AUTOCLOSE duration when PartyMode
because turning the system back on will automatically reengage the AUTOCLOSE feature.
A . Press and hold the
SET AUTOCLOSE TIME
B. Release the
ing at the rate of 1 blink per second
C. Within 5 seconds, press and release the
feature.
D. The AUTOCLOSE feature is now disabled until you enable it with a new setting. IF THE AUTOCLOSE LED
IS STILL ON, THE AUTOCLOSE HAS NOT BEEN DISABLED.
AUTOCLOSE LED INDICATOR
The AUTOCLOSE LED indicates which mode the gate system controller is currently in. Note, that this LED will turn OFF
after one minute of inactivity to conserve system power.
LED Solid On LED Blinking On & Off
AUTOCLOSE AUTOCLOSE is enabled but temporarily suspended
is enabled because PartyMode has been activated. Disabling
PartyMode will turn the LED back to a Solid On.
© G h o s t C o n t r o l s 2 0 1 9
®
is disabled. Turning the control board off will not remove AUTOCLOSE
®
SET AUTOCLOSE TIME
button. The LED next to the AUTOCLOSE button will start blink-
SET AUTOCLOSE TIME
to temporarily disable AUTOCLOSE and the system will retain your
button until it beeps.
LED Off
Assuming system has been active within the
last minute, this indicates that AUTOCLOSE
is disabled.
button to disable the AUTOCLOSE