Setup System Controller - Ghost Controls DEP2 Installation And Owner's Manual

PREPARING THE GATE SYSTEM CONTROLLER
The gate system control board provides one convenient place to make all of your system connections and to change any
settings that you desire to personalize how your automatic gate opener system operates at your home or property. This main
board (shown below) is located inside of the control box of your system and will be referred to in detail through the next few
sections. Because this control box may be mounted within reach of children or potential vandals, we offer and recommend an
operator lock security kit (AX2L) as an accessory to safely lock this box in the closed position to prevent tampering. NOTE:
BEFORE PROCEEDING MAKE SURE THE ON/OFF SWITCH ON BOTTOM OF CONTROL BOX IS IN THE
OFF POSITION.
STEP 10. Check the system DIP switch settings and verify in the correct positions as shown.
DIP Switch # OFF Position
1
2
3
4
 Factory Default:
Pull-To-Open
 Warning Disabled
 Factory Default:
SafeForce Mode
®
 Factory Default:
Delay Open 2nd Arm
ON Position
 Push-To-Open
 Factory Default: Warning Enabled
 Monitored External Safety Devices Mode
 Simultaneous Open
P U S H - T O - O P E N
© G h o s t C o n t r o l s 2 0 1 9
51