Showven SPARKULAR JET User Manual page 5

4. Advanced Menu:
Press "MENU" switch through setup menu.
Options
Set Temperature
Auto Heat
Jet Delay
Mode Selection
Standby Switch
Ext. Ignite
Feeding Test
Fan Test
Feeding1 Time
Feeding2 Time
*Please don't change default value without engineer's suggestion from SHOWVEN
5. DMX channel – 2 channel mode:
First channel
0-111
112-255
Second channel
60-80
20-40
0-10
240-255
Range
580-620
On/Off
0.5-2.0s firing on DMX/controller (firing trigger) and
Factory Mode/ User
Mode
On/Off
On/Off
On/Off
On/Off
0.1-0.3s
Working time of shaft motor, Feeding2 time
0.5-3.0
Explanation
Set inner core temp
Auto heat ON/OFF when switch on machine
Firing delay set, time delay between press
actual sparks out from the nozzle
Factory mode is for engineer only. When in
Factory mode machine can't controlled by
DMX console/host controller
Standby function. When ON, the machine
can firing only when heating up was
finished
When use fireworks firing system to firing
the machine. Customized design for
fireworks customer
Test the feeding structure and feeding
motor
Test the blowing fan
Feeding time of the HC8200 from the
hopper
should shorter than Jet Delay time
Function
no function
Firing. To avoid false triggering, the trigger
time should maintain above 0.2s
Function
Clear material, the valve will open when
clear matrial, and clear the consumable
remains in the pipeline. Please DO
remember to clear material after each show
Emergency stop, when firing was triggered,
operator can stop the firing during this jet
delay period. And machine will prompt E0
error
Pre-heat OFF (disabled when auto-heat ON)
Pre-heat ON (disabled when auto-heat ON)