Table of Contents
Advertisement
▲Interface
1. Main Interface:
DMX:
11
T:
19
First Line: DMX address, current pressure value
Second Line: inner core temp. delayed firing time
The working principle of the machine is when the firing is triggered, it takes some time (jet
delay) for the system to transfer and stimulate the consumables. When it reached the delayed
firing time, the valve will open automatically and firing activated
2. Error information:
Error information
E0 System IC
E1 Pump Protect
E2 Temp. Sensor
E3 P Temp. Over
E4 Time Remain
E5 K Temp. Over
E6 Heat Fail
3. Setting Menu:
Press "MENU" switch through setup menu.
Options
Set DMX Address
Set Pressure
Manual Clear
P:
0
Delay: 1.0s
1. Emergency stop was executed when
firing was triggered, and firing stops. E0
disappear automatically 1min later
2. Too frequent firing in a short period of
It happens when continuous pressurization
fail, probably the pump was malfunction
Temperature sensor is not connected or
Activated time for machine is not enough,
Heating fail, if recover automatically, please
pay attention to the power supply
Range
If controlled by Host Controller, please set
1-512
DMX address as 1, 3, 5, 7,...2n-1, otherwise
it may leads to signal interference
Adjust the pressure value, the higher the
pressure, the higher the effect; After
15-45
change the pressure please make a manual
clear to reset the pressure inside machine.
Manual clear material. Please be careful, do
On/Off
Explanation
time, E0 disappear 100s later
damage
Chassis over-temperature
need to swap RFID card
Inner core over-temperature
Explanation
Set DMX address.
NOT close to the nozzle
Advertisement
Table of Contents
Need help?
Do you have a question about the SPARKULAR JET and is the answer not in the manual?
Questions and answers