Password Setting; Ide Hdd Auto Detection - Advantech PPC-A84/A120-X5X User Manual

The options for Port 3 are: 3E8/IRQ10 (Default), 2E8/IRQ5, Disabled.
The options for Port 4 are: 2E8/IRQ5 (Default), Disabled, 3E8/IRQ10.

8.11 Password Setting

To enable the password setting, select the item from the Standard
CMOS Setup. You will be prompted to create your own password.
Type your password up to eight characters and press "Enter". You will
be asked to confirm the password. Type the password again and press
"Enter". You may also press "Esc" to abort the selection and not enter
a password. To disable the password, press "Enter" when you are
prompted to enter the password. A message will appear, confirming
the password is disabled.
Under the BIOS Features setup, if "System" is selected under the
Security Option field and the Supervisor Password is enabled, you will
be
prompted for the supervisor password every time you try to enter the
CMOS Setup utility. If "System" is selected and User Password is
enabled, you will be requested to enter the user password every time
you reboot the system. If "Setup" is selected under the Security Option
field and User Password is enabled, you will be prompted only when
you reboot the system.

8.12 IDE HDD Auto Detection

The IDE Hard Disk Drive Auto Detection feature automatically
configures your new hard disk. Use it for quick configuration of new
hard disk drives. This feature allows you to set the parameters of up to
four IDE HDDs. The option with "(Y)" is recommended by the system
BIOS. You may also key in your own parameters instead of setting
them
according to the system BIOS. After keying in all settings, press "Esc"
to return to the main menu. For confirmation, enter the Standard
CMOS Setup feature.
118 PPC-A84/A120 User's Manual