Table of Contents
Advertisement
Onboard Parallel Port
If the parallel port uses the onboard I/O controller, you can modify
your parallel port paramaters. When you select "Disabled", the next
two setup items will disappear.
The options are: 378/IRQ7 (Default), 3BC/IRQ7, 278/IRQ5, Disabled.
Parallel Port Mode
You can choose different data transfer modes for your system.
The options are: ECP & EPP (Default), SPP, EPP, ECP.
ECP Mode Use DMA
You can choose different DMA modes for data transfer.
The options are: 3 (Default), 1.
9.11 Password Setting
To enable the password setting, select the item from the Standard
CMOS Setup. You will be prompted to create your own password.
Type your password up to eight characters and press "Enter". You will
be asked to confirm the password. Type the password again and press
"Enter". You may also press "Esc" to abort the selection and not enter
a password. To disable the password, press "Enter" when you are
prompted to enter the password. A message will appear, confirming the
password is disabled.
Under the BIOS Features setup, if "System" is selected under the
Security Option field and the Supervisor Password is enabled, you will
be
prompted for the supervisor password every time you try to enter the
CMOS Setup utility. If "System" is selected and User Password is
enabled, you will be requested to enter the user password every time
you reboot the system. If "Setup" is selected under the Security
Option field and User Password is enabled, you will be prompted only
when you reboot the system.
102
PPC-153 User's Manual
Advertisement
Table of Contents
