Jumpers And Connectors; Setting Jumpers - Advantech PPC-A84/A120-X5X User Manual

Ns gxm/gx1 processor-based panel pc with 8.4"/12.1" lcd flat panel display

Table of Contents

3.3 Jumpers and Connectors

You can configure your panel PC to match the needs of your applica-

tion by setting jumpers. A jumper is the simplest kind of electrical

switch. It consists of two metal pins and a small metal clip (often

protected by a plastic cover) that slides over the pins to connect them.

To "close" a jumper, you connect the pins with the clip. To "open" a

jumper you remove the clip. Sometimes a jumper will have three pins,

labeled 1, 2, and 3. In this case, you would connect either pins 1 and 2

or pins 2 and 3.

The jumper settings are schematically depicted in this manual as

follows:

A pair of needle-nose pliers may be helpful when working with

jumpers.

If you have any doubts about the best hardware configuration for your

application, contact your local distributor or sales representative

before you make any changes.

PPC-A84/A120 User's Manual

Open

Closed

Closed 2 - 3

Table of Contents

Ppc-a84 A120-x5x