Mount The Pump - VERDER Verderair VA-E80 Operation

Mount the the Pump Pump
Mount Mount the Pump
To avoid serious injury or death from toxic fluid or
fumes:
• Never move or lift a pump under pressure. If
dropped, the fluid section may rupture. Always
follow the Pressure Relief Procedure, page
before moving or lifting the pump.
• Do not expose pump or the plastic components
to direct sunlight for prolonged periods.
Prolonged exposure to UV radiation will degrade
natural polypropylene components of the pumps.
NOTICE NOTICE NOTICE
The pump is heavy. To prevent damage from
dropping, always use a lift to move the pump. Do
not use the manifolds to lift the pump. Use at least
two straps.
1. Ensure that the mounting surface is level and
can support the weight of the pump, lines, and
accessories, as well as the stress caused during
operation.
2. Adjust the leveling feet on the gear motor
mounting bracket so that all mounting points are
well supported and the pump does not wobble.
3. Bolt the pump to the floor through the mounting
holes (B) to secure the pump in position. See
Dimensions, page 24.
NOTE: For ease of operation and service, mount
NOTE: NOTE:
the pump so fluid inlet and fluid outlet ports are
easily accessible.
NOTICE
NOTICE NOTICE
To prevent pump damage, use all eight
fasteners.
859.0634
Mounting a a a pump
Mounting Mounting
A pump without a Verder gearbox and motor will
require a mounting platform to provide support
for the customer-supplied motor and gearbox
and provide alignment with the pump alignment
housing (116) and drive shaft (112) without putting
strain on the mounting platform or pump. See
Dimensions, page 24
mounting platform.
17,
REF REF REF DESCRIPTION DESCRIPTION DESCRIPTION
AA
Gearbox coupler bore and
keyway
BB Flange pilot diameter
CC Bolt circle diameter
DD Mounting hole thread size
To specify a non-Verder gearbox, refer to the figure
and table above.
pump without without a a a Gearmotor Gearmotor
pump without Gearmotor
for assistance in fabricating a
Installation
DIMENSION DIMENSION DIMENSION
35 mm/10
mm keyway
110 mm
130 mm
M8 x 1.25
11