Mount The Pump - VERDER VERDERAIR VA-E50 Operation

Installation
Mount Mount the Mount the Pump the Pump Pump
To avoid serious injury or death from toxic fluid or
fumes:
• Never move or lift a pump under pressure. If
dropped, the fluid section may rupture. Always
follow the Pressure Relief Procedure, page
before moving or lifting the pump.
NOTICE NOTICE NOTICE
The pump is heavy. To prevent damage from
dropping, always use a lift to move the pump. Do
not use the manifolds to lift the pump. Use at least
two straps.
1. For all mountings, be sure the pump is secured
with screws through the mounting feet (D) and
through the mounting bracket or compressor box
on the gear box. See
NOTICE NOTICE NOTICE
To prevent pump damage, use all eight
fasteners.
2. Make sure the mounting surface is flat and that
the pump doesn't wobble.
3. For ease of operation and service, mount the
pump so fluid inlet and fluid outlet ports are easily
accessible.
12
All manuals and user guides at all-guides.com
20,
Dimensions, page 27.
Mounting a a a pump pump without without a a a Gearmotor
Mounting Mounting pump without
A pump without a Verder gearbox and motor will
require a mounting platform to provide support
for the customer-supplied motor and gearbox
and provide alignment with the pump alignment
housing (116) and drive shaft (112) without putting
strain on the mounting platform or pump. See
Dimensions, page 27 for assistance in fabricating a
mounting platform.
REF REF REF DESCRIPTION DESCRIPTION DESCRIPTION
A Gearbox coupler bore and
keyway
B Flange pilot diameter
C Bolt circle diameter
D Mounting hole thread size
To specify a non-Verder gearbox, refer to the figure
and table above.
Gearmotor
Gearmotor
DIMENSION DIMENSION DIMENSION
35 mm/10
mm keyway
110 mm
130 mm
M8 x 1.25
859.0761