Pump Matrix - VERDER VERDERAIR E-PURE ATEX Manual

PUMP MATRIX

Before putting your pump in operation remove
all packing materials after reception. Check the
consignment for damage at once and make
sure that the name plate / type designation is in
accordance with the packing slip and your order.
All pumps have identification plate (ID) located
on the pump housing. The ID is mentioning the
year of construction, the serial number and the
construction code of the pump.
Pump size Housing and center Section
Housing
30 : 3/4" G: PE-Conductive
50 : 3/4"
100 : 1 1/4"
Diaphragm Connections
TO : PTFE TN : Threated NPT
Overmolded TB : Threated BSPP
(non-codictive) FD-S: Flange DIN in
SS304
FD : Full steel flange
DIN in SS316
Example : VA-EP100GA SS FP TO TN X3OO
II 3G Exh IIC T3 Gc
Notes:
- Not all combinations are available, contact your
local supplier for more info.
Use the matrix below to define the components
of your pump. Make sure the wetted parts of the
pump are compatible to the pumped liquid.
NOTE:
In case of doubt, please contact your local supplier
(www.verderliquids.com). To build a pump code,
please see the below coding system.
PUMPCODING VA-EP ATEX
Drive section
A : Aluminum + PE-C SS : Stainless steel 316L
Options
X3: ATEX AC drive 230/400V 50Hz.
XI: Gearbox ATEX i=7.5 flange IEC80.
STORAGE
If the pump is not installed immediately it is
recommended to store it in a dry, clean and cool
location. Verderair e-Pure pump is tested with
water as liquid according to the test report.
Note: Rest water from the test may stay behind in
the pump.
Shafts & diaphragm plate
-
DS : Duplex ss
HS : Hastelloy C
OO : standard, right suction port
LP : left suction port
LX: leak detection, ATEX sensor
DM: Draining manual
VERDERAIR E-PURE ATEX_v1 | 30.10.2023
e-
Valve
FP : Flapper PEEK
3