Taylor-Dunn BurdenMaster B 2-00 Operation, T Roubleshooting And Replacement Parts Manual page 87

Current Taylor-Dunn
possibility that the original brakes were replaced with aftermarket
parts containing asbestos. Since this possibility exists, all brake parts
should be handled as if they contain asbestos. Refer to appendix C
for recommended handling precautions.
9. Remove and inspect the brake drum. Refer to
information regarding inspecting the brake drum.
10. Remove the retracting springs and torsion springs
from the brake shoes.
11. Remove the hair pin clips from the actuating arms
and discard.
12. Remove the brake shoes and brake adjustor
assembly from the backing plate.
13. Thoroughly clean and inspect the adjustor
assembly. Replace parts as required.
14. Apply a very light coating of high temperature
grease to the adjustor screw threads.
15. Install in reverse order.
16. Repeat for the opposite side.
17. Adjust the brakes. See
Brakes
section for information regarding adjusting the brakes.
18. Set the park brake.
19. Reconnect the main positive and negative at the batteries.
20. Lower the wheels to the ground.
21. Remove the blocks from behind the wheels.
22. Release the park brake and test drive the vehicle.
Maintenance, Service, and Repair
brakes are asbestos free. However, there is the
®
Inspect the Service Brake
Adjust the Service
Brakes Page 19
section for