Taylor-Dunn BurdenMaster B 2-00 Operation, T Roubleshooting And Replacement Parts Manual page 143

7. Place the transmission on to the locating pins on
each leaf spring.
8. Install the four u-bolts so that the u-bolt nuts are
tight enough to hold the springs on the locating pins
but not so tight as to keep the springs from moving.
9. Install the lower spring hanger bolts. Torque to 20
ft-lbs.
10. Tighten the u-bolt nuts.
11. Install the brake cable. Use a new cotter pin.
12. Adjust the brakes. Refer to the
section for information regarding adjusting the
brakes.
13. Adjust the mechanical brake linkages. Refer to the
Brake Service
section for information regarding
adjusting the brake linkages.
14. If equipped with hydraulic brakes, install the brake line and bleed the brakes. Refer to the
Brake Service
section for information regarding bleeding the brakes.
15. Connect the wires to the motor.
16. Reconnect the main positive and negative at the batteries, remove the blocks from the wheels,
and test drive.
Maintenance, Service, and Repair
Brake Service
Transmission Page 11