YOKOGAWA WE7281 User Manual page 38

4-ch, 100 ks/s d/a module

Table of Contents

Setting the Output Timing of the Trigger Signal

The trigger operation panel shown below is used to set the output timing.

Selecting the source channel.

In the menu that appears by clicking the [Source] button, select the source channel that

will be used to output the trigger signal.

Set the output timing

In the [Phase] entry box, specify at which phase of the output waveform of the source

channel to output the trigger signal. The range is 0 to 360 deg.

Setting the Sweep

The Main (SlotX) and Swp operation panels are used to set the sweep.

Slot tab

Selecting the parameter to sweep

Select which parameter to sweep in the Main operation panel. The choices are shown

below.

Off

Freq

Ampl

Duty

Freq & Ampl : Sweep the frequency and amplitude

IM 707281-01E

Trig tab

Set the output timing

Select the parameter to sweep

Select the sweep pattern

: Do not sweep

: Sweep the frequency

: Sweep the amplitude

: Sweep the duty cycle

3.4 Setting the Output Condition in the FG Mode

Select the output channel

Swp tab

Select the sweep mode

Set the sweep time

Select the channel to sweep

Load the sweep pattern

3-13

Table of Contents

We7282