YOKOGAWA WE7281 User Manual page 30

Setting the Output Timing of the Trigger Signal
Setting the Memory Partition, Time Base, and Arbitrary Waveform Data Loading
IM 707281-01E
The trigger operation panel shown below is used to set the output timing.
Trig tab
Set the output timing of the trigger signal
Specify at what position of the output waveform to output the trigger signal in the [Point]
entry box. The range is from 1 to the data length. For details regarding the data length,
see page 1-7.
The Misc operation panel shown below is used to set the following settings.
Set auto load
Misc tab
Set the output start/end block
Select the time base
Selecting the time base
Select which of the following time bases to use during data output in the [Time Base] list
box.
Internal : Sample the waveform data using the sampling interval based on the
module's internal clock
BUSCLK : Sample the waveform data by synchronizing to the time base signal of the
measuring station (CMNCLK)*
* For setting procedures, see section 4.6, "Setting the Trigger Source/Time Base
Source/Arming" in the WE7000 User's Manual (IM707001-01E).
Setting the sampling interval
Set the interval when sampling the waveform data using the internal clock. When auto
load is used to load waveform data in wvf format, the sampling interval of the waveform
data is also loaded. However, this value can be changed by entering a value in the
[Sampling Interval] entry box. A value can be entered in the [Sampling Interval] entry box
only when the time base is set to internal clock. The range is 10 µs to 10 s. The
resolution is 10 µs. The default is 10 µs.
3.3 Setting the Output Condition in the AG Mode
Set the slot/channel to be loaded
Select the block to be loaded
Select the number of channels
to use
Set the sampling interval
Select memory partitions
Set the data length
3
3-5