LinMot B1100-PP Installation Manual page 13

Installation Guide B1100
Logic Supply:
DSUB-25 (f)
Switch Mode Power Supply: 24VDC (22...26VDC)
External Fuse:
All Digital Inputs:
Direct interfacing to digital 24VDC PLC outputs.
Input Current:
Sample Rate:
All Digital Outputs:
Short circuit and overload protected high side switches.
Voltage:
Update Rate:
Max. Current:
Peak Current:
Outputs may directly drive inductive loads. Do not connect any capacity because of the peak current!
Analog Input on X14.20:
Range: 0V..+10V
Sample Rate:
Differential Analog Input on X14.8 X14.21 X14.9 Shield:
Range: -10V..+10V 10Bit ADC
Sample Rate:
Differential Step Dir Zero:
Indexer Inputs:
edge separation
1 If an input is used as a trigger input, the sampling rate is set to 200us.
NTI AG, LinMot
2AT
1mA
400us 1
24VDC
400us
100mA/500mA (X14.17)
370mA/1100mA (X14.17) will shut down if exceeds
10Bit ADC
400us
400us
RS422, Max. Input Frequency: 2MHz, 4 M counts/s with quadrature decoding, 240ns
Installation Guide B1100 Page 13/18