Sequence; Address Of Start Command - VALMETAL PAN-SPEC Manual

MANURE CONTROL

9.2 Sequence

In the TECHNICIAN ACCESS SEQUENCE, you can change the start and stop of the sequence and
interlock sequence together.

Address of Start Command

9.2.1
In that box you can modified the condition to start the sequence.
HIGH/LOW:
The actual level must be higher than the setpoint.
The actual level must be lower than the setpoint.
TECHNICAN'S MANUAL V0.3
Address: Address of the PLC digital input.
Delay: Delay that the condition needs to be true to
start the sequence.
Type: Normally open or normally closed contact.
Equipment: Programmed level sensor.
Start by Level %: level setpoint.
2020-02-19
27