Table of Contents
Advertisement
MANURE CONTROL
8.3 Alarm and Warning List
General Alarm
8.3.1
"EMERGENCY STOP": Emergency stop button in front of the main panel have been press.
"POWER FAILIRE": A lost of power have been detected.
"COMMUNICATION FAILURE : (REMOTE PANEL NAME)": Lost of communication between the
main and a remote panel.
"EMERGENCY STOP : (REMOTE PANEL NAME)": Emergency stop button in the front of a remote
panel have been press.
"PLC Bus in Fault" : Error between the PLC and a IO card.
"ERROR COMMUNICATION MASTER MODBUS RTU": The PLC is not able to communicate with
the smart overloads.
"SYSTEM HAS FAILED TO SEND EMAIL'": Unable to send email.
Equipment Alarm
8.3.2
"(Equipment Name) : Warning Stacking Sensor": The stacking sensor have been activated.
"(Equipment Name) : Alarm Stacking Sensor": The stacking sensor have been activated for
longer than the programmed delay.
"(Equipment Name) : Overload Screw Press": The actual current of the screw has been above
the limit for longer than the programmed delay.
"(Equipment Name) : Alarm Rotation Sensor": The rotation probe does not respond.
"(Equipment Name) : Emergency Stop" (VFD only): The emergency stop input on the VFD is
activated.
"(Equipment Name) : Alarm Hopper ON" : The hopper sensor have been activated for longer
than the programmed delay.
"(Equipment Name) : Error Modbus Communication" (Contactor Only): Communication lost
with a smart overload.
Sequence Alarm
8.3.3
"WARNING : START CONDTION ON AT THE END OF SEQUENCE #": The maximum runtime of
the sequence has been reached even if the start condition is still true.
TECHNICAN'S MANUAL V0.3
2020-02-19
22
Advertisement
Table of Contents
