MANURE CONTROL
8.2 Event Parameter
To program event, press on EVENT PARAMETER.
You can create up to 5 event that could come from an input, output, level or an equipment
TYPE:
•
Input: PLC Digital input. See Section 5.
•
Output: PLC Digital Output. See Section 5.
•
Level: Analog Input, mainly use for level.
•
Equipment: Equipment is started.
ADDRESS/EQUIPMENT:
•
Type INPUT or OUTPUT: Address of the digital input or output. See section 5.
•
Type Level: Programmed Level Sensor.
•
Type Equipment: Programmed Equipment
DESCRIPTION: Message that will appear.
HIGH/LOW:
Up Arrow: Rising Edge of the condition will generate an event.
Down Arrow: Falling Edge of the condition will generate an event.
Level %: The level setpoint if the type is set to Level.
TECHNICAN'S MANUAL V0.3
2020-02-19
21