VALMETAL PAN-SPEC Manual page 6

MANURE CONTROL
System Information
Read these guidelines carefully before executing any procedure with this system.
RISK OF ELECTROCUTION, EXPLOSION OR ELECTRIC ARC
•
Only certain individuals are authorized to work on and with this system. They must be
adequately trained, know and understand the contents of this manual and of any
other relevant documents pertaining to the product and must have been trained in
the field of safety in order to identify and avoid risks. The installation, adjustments,
repair and maintenance must be performed by qualified personnel.
•
The installing electrician is obliged to guarantee compliance with local and national
regulation requirements regarding grounding of all equipment.
•
Many of the components inside the box operate on mains voltage. Do not touch
them.
•
Only use the tools and measurement equipment which have been appropriately
calibrated and electrically isolated.
•
Do not touch the terminal screws or unshielded components when voltage is on.
•
The motor generates voltage as the shaft turns. Before executing any type of work on
the system, block the motor shaft to avoid rotation.
•
AC voltage may couple with the voltage to unused conductors in the motor cable.
Isolate both ends of the unused conductors of the motor cable.
•
Before working inside the box:
o Disconnect any potentially active supply.
o Affix a label with the legend Do Not Start on every switch connected to the
system.
o Block all switches in the open position.
•
Before turning on the power on the box:
o Check that the work is completed and that the installation does not pose any
danger.
o If the power input terminals and the output motor terminals have been
grounded and short-circuited, remove the grounding and the short circuits on
the power input terminals and the output motor terminals.
o Check that all the equipment is correctly grounded.
o Check that all protective equipment is installed and/or closed.
Failure to comply with these instructions may result in death or serious injuries.
TECHNICAN'S MANUAL V0.3
DANGER
2020-02-19
6