Module Reset; Hard Reset - Directed Xpresskit DBALL2 Installation Manual

Platform: DBALL2
Firmware: CHRYSLER11 ange Extender

Module Reset

A module reset will only erase programming performed in the previous steps. All settings (firmware) and settings flashed
to the module using the web config tool will not be affected.
If required for your installation, connect the 10-pin & 12-pin
1
harnesses to the module Press
button, then connect the 14-pin harness to the module.
Wait 3 seconds until the
2
p rogramming button.

Hard Reset

Warning gainst xecuting a Hard Reset! A E
A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some settings (such
as RFTD and D2D options) may have to be reconfigured. See the
If required for your installation, connect the 10-pin & 12-pin
1
harnesses to the module Press
button, then connect the 14-pin harness to the module.
Wait 3 seconds until the
2
until the LED starts to flash orange
3
Release the programming button. The
R Ready
. and hold the rogramming p
LED turns ON solid orange then release the
The LED turns ON solid red.
. and hold the rogramming p
LED turns ON solid orange
and red.
LED turns
(RXT) Installation
st
1
Feature & Option List
st
1
, and w ait 10 more seconds
ON solid red.
Rev.: 20170724
th
4
nd
2
rd
3
& &
Solid Release Solid
section of this guide.
th
4
nd
2
rd
3
&
Solid Flashes
&
Release Solid
© 2017 Directed. All rights reserved.
Page 9