AC Infinity CLOUDRAY T10 User Manual page 26

PROGRAMMING
TIMER TO OFF MODE
In this mode, press the up or down button to set a
countdown time. The fans will run at the speed set
in ON Mode until the countdown ends. If there was a
speed set in OFF Mode other than zero, then the fans
will run at that speed after the end of the countdown.
The countdown will begin if no buttons are pressed for
5 seconds. The time left on the countdown is shown
on the display, in the section below the current fan
speed. Leaving the timer mode while the countdown
is running will pause it until you return to this mode.
Leaving the timer mode while the countdown is
running will pause it until you return to this mode.
CYCLE MODE (ON AND OFF)
In this mode, set an on duration and an off duration
for the fan to cycle through continuously. Press the
up or down button to first set a duration for the fan
to be on and then press the mode button again, to
set a duration for the fan to be off. When the fan is
triggered to be on, it will run at the speed set in ON
Mode. When the fan is triggered to be off, it will run
at the speed set in OFF Mode.
The countdown will begin if no buttons are pressed
for 5 seconds. The time left on the countdown
before the next on or off phase is shown on the
display, in the section below the current fan speed.
Leaving the cycle mode while the countdown is
running will pause it until you return to this mode.
26
If there is a speed set in OFF Mode other
than zero, the fans will run at that speed
when triggered to turn off.
If there is a speed set in OFF Mode other
than zero, the fans will run at that speed
when triggered to turn off.
PM
TO
OFF
OFF