Routine Cleaning And Maintenance - Enviro Mini 2 Operator's Manual

Routine Cleaning and Maintenance

The following list of components should be inspected and maintained routinely to ensure that the
appliance is operating at its' optimum and giving you excellent heat value:
2-3 Days / Weekly
Burn Pot and Liner
Heat Exchanger Tubes
Ash Pan
Door Glass
Inside Firebox
Ash Pan and Door Gaskets
Door Latch
TOOLS REQUIRED TO CLEAN UNIT:
Torx T-20 Screwdriver,
Cloth, Vacuum with fine filter bag
BURNER POT AND LINER (2-3 days)
Every two to three days (when the unit is cold), remove the burn-pot liner from the stove. Using a
metal scraper, remove material that has accumulated or is clogging the liner's holes. Then dispose of
the scraped ashes from the liner and from inside the burn-pot. Place the burn-pot back into the stove,
making sure that the pipes are properly inserted into the burn pot. Place the liner back into the burn-pot,
making sure that the ignitor hole in the liner is aligned with the ignitor tube (shown in Figure 32). Push
the liner up against the ignitor tube.
If after long periods of burning, the fire continually builds up and overflows the burn pot or there is a
build up of clinkers, this is an indication that the pellet fuel quality is poor, the stove may need cleaning,
or the air adjusted. Check the stove for ash build up (clean if required) and adjust the damper to produce
the proper clean combustion.
heat exchanger tubeS (2-3 days)
A rod is located in the center of the stove just above the door behind the top louvers, see Figure 35. This
rod is to be pulled up and down a few times (ONLY WHEN THE UNIT IS COLD) in order to clean away
any fly ash that may have collected on the heat exchanger tubes. As different types of pellets produce
different amounts of ash, cleaning of the tubes should be done on a regular basis to enable the unit to
run efficiently. Do pull on rod excessively if it is not sliding. If stuck inspect rod for bend and try and free
up scraper plate from inside firebox.
ASH PAN AND DOOR GASKETS (weekly)
After extended use the gasket may come loose. To repair this, glue the gasket on using high-temperature
fiberglass gasket glue available from your local dealer. This is important to maintain an airtight assembly.
Semi-annually or 2 Tons of Fuel
Exhaust Vent
Air Intake
Blower Mechanisms
Heat Exchanger Tubes
Behind Firebox Liners & Covers
All Hinges
Post Season Clean-up
5 / " wrench or socket, Brush, Soft
16
Air Intake Tube
Figure 26: P3 Burn pot and Liner
Burn Pot Liner
Ignitor Hole
Ignitor Tube
Burn Pot
23