Inside Vertical Installations; Outside Vertical Installations - Enviro Mini 2 Operator's Manual

I v I
nSIDe ertIcaL nStaLLatIonS
Rain Cap (ensure cap is
at least 3ft above the
roof at the lowest point)
Roof Flashing
Roof Rafter
Fire Stop with
Support Collar
Ceiling Joist
Vertical Vent Pipe
Clean Out Tee with
Pipe Adapter
NOTE: All vent sections must
maintain 3 inches (7.5 cm)
clearances to combustibles.
Figure 16: Inside Vertical Installation.
o v I
utSIDe ertIcaL nStaLLatIonS
To accomplish a outside vertical pipe installation, follow
steps 1 through 5 in the "i
F " section and then finish it by performing the
reestanDing
following (refer to Figure 17).
1. Install a tee with clean out on the outside of the house.
2. Install PL vent upward from the tee. Make sure that
you install support brackets to keep the vent straight
and secure.
3. Install ceiling thimble and secure the flashing as you
go through the roof.
4. Ensure that the rain cap is approximately 24" (600
mm) above the roof.
16
Installation
:
2 ft
(600 mm)
:
V i
nsiDe erticaL nstaLLations
1. Choose a stove location that is ideal. See the section
"D W
eciDing here to
2. Place a non-combustible hearth pad where
necessary.
3. Place the unit on the hearth pad (if installed on a
combustible surface) and space the unit in a manner
so when the pellet vent is installed vertically, it will
be 3" (7.5 cm) away from a combustible wall.
4. Install the tee with clean out.
5. nstall the pellet vent upward from there. When
I
you reach the ceiling, make sure that the vent goes
through the ceiling fire stop. Maintain a 3" (7.5 cm)
distance to combustibles and keep attic insulation
away from the vent pipe. Maintain an effective
vapor barrier.
6. Finally, extend the pellet vent to go through the
roof flashing.
7. Ensure that the rain cap is approximately 24" (600
mm) above the roof.
-
Figure 17: Outside Vertical Installation.
L P a
ocate your eLLet PPLiance
Rain cap
Flashing
4"
(10 cm)
Type "PL"
vent
."
24"
(61 cm)
3" (7.5 cm)
Clearance
Support
bracket
Tee with
cleanout