Connecting External Scsi Devices - Adaptec 2930U User Manual

Connecting External SCSI Devices

The SCSI Card 2930CU has one 50-pin high-density external
connector. You will need a high-quality 50-pin high-density
external SCSI cable for each external SCSI device you are
connecting. External SCSI cables are not included in the SCSI Card
2930CU kit. Refer to
information.
To connect external SCSI devices
1 Ensure that each external SCSI device has a unique SCSI ID from 0
to 6. For most external SCSI devices, the SCSI ID is set with a
switch on the back of the device, as shown. Refer to the SCSI
device's documentation for instructions on setting the SCSI ID.
Note: Each device connected to your SCSI Card 2930CU
(both internal and external) must have a unique SCSI ID
from 0 to 6. You cannot use the same SCSI ID twice.
2 If your computer is running, turn it off and disconnect the power
cord.
3 Connect one end of an external SCSI cable to the SCSI Card 2930CU
external SCSI connector. Secure the cable by tightening the
screws on the cable connector.
Note: Avoid touching the device connector pins.
Chapter D, Obtaining SCSI Cables
Installing SCSI Devices
for more
SCSI ID
3-5