Adaptec 2930U User Manual page 48

Error Code Description
[xxxxx022] Adapter or target device protocol error. The
adapter or target device has broken the
communication protocol. A faulty device could
cause this message to appear. Normally this is not
a serious problem. If you get this message
frequently over a short period of time, it could
indicate that the device or system is
malfunctioning. Unplug or power down unused
devices to see if the problem persists.
Target device parity error. The driver has
[xxxxx023]
detected a parity error by the target device.
[xxxxx024] Data overrun or underrun. The adapter was
given more or less data than the expected amount
of data.
[xxxxx031] Target device queue full. The target device
internal buffer is full.
[xxxxx032] Target device busy. The target device reports a
Busy status. Another program may already be
using this device.
[xxxxx050] Host adapter failure. Your host adapter may not
[xxxxxx9A]
be properly installed or is defective. Try reseating
the adapter in the PCI slot, or try installing it a
different PCI slot.
[xxxxx081] Adapter initialization failure. An error has
[xxxxxx8A]
occurred while the driver was setting up its
[xxxxxx83]
internal data structures. Verify that your adapter
is supported by this version of the driver.
Unable to allocate memory. This indicates that
[xxxxx089]
there may be a problem with the amount of
memory installed in your system. Verify that
your system has at least the minimum amount of
memory required by your operating system.
Troubleshooting
5-12