Adaptec 2930U User Manual page 22

4 Connect the other end of the cable to a SCSI connector on the
back of the SCSI device.
5 If you are installing only one external SCSI device, terminate the
device.
Refer to your SCSI device's documentation for termination
instructions.
6 Connect other external SCSI devices by cabling each device to
the previous one, as shown. Only terminate the SCSI device at
the end of the chain.
Unterminated devices
Terminated device
7 Reconnect the power cord to the computer and connect power
cables to the external SCSI devices.
8 Turn on the SCSI devices and allow them to power up. Then
turn on the computer.
9 Install the driver. See
information.
Chapter 4, Installing Drivers
Installing SCSI Devices
for more
3-6