Connecting External Scsi Devices - Adaptec ULTRA160 Manual

Connect a power cable from your computer's internal power
S 5
TEP
supply to each internal device.
Power Input Connector on
the Back of the Device

Connecting External SCSI Devices

Connect external LVD SCSI devices to the 68-pin external
LVD/SE SCSI connector. Each external device will require a
68-pin external LVD SCSI cable.
N
OTE
devices to the external SCSI connector. If you also attach
older Ultra SCSI devices, the data transfer speed of the LVD
SCSI devices will drop to the speed of the older devices. (See
Bus Segments on the Adaptec SCSI Card 29160 on page 4.)
Follow these steps to connect the external devices:
Connect one end of the external LVD SCSI cable to the external
S 1
TEP
LVD/SE connector on the Adaptec SCSI Card 29160.
68-pin External
LVD/SE SCSI
Connector
We recommend that you connect only LVD SCSI
Adaptec SCSI Card 29160
Power Cable (From the Power
Supply Inside the Computer)
68-pin External
LVD SCSI Cable
15