Connecting External Scsi Devices - Adaptec 29320LP-R Manual

Connect a power cable from your computer's internal power
S 4
TEP
supply to each internal SCSI device.

Connecting External SCSI Devices

You can connect external Ultra320/160 and Ultra2 SCSI devices
to the 68-pin external LVD/VHDCI connector. Each external
device will require a 68-pin VHDCI external LVD SCSI cable.
Follow these steps to connect your external SCSI devices:
Connect one end of an external SCSI cable to the external
S 1
TEP
Ultra320/160 connector on the Adaptec SCSI Card 29320LP.
68-pin external
LVD/VHDCI SCSI
connector
Connect the other end of the cable to a SCSI connector on the
S 2
TEP
back of an external device. If you are installing only one external
device, terminate the device and skip to Step 4.
7
VHDCI external
LVD SCSI cable
SCSI terminator