Adaptec 2930U User Manual page 20

7 Connect any other internal SCSI devices, as shown.
Terminated internal SCSI device
Unterminated internal SCSI device
8 Terminate the device that is connected to the end of the cable.
Refer to the SCSI device's documentation for instructions.
9 Connect a power cable from your computer's power supply to
the power input connector on the SCSI device, as shown. Repeat
this step for each SCSI device.
Power cable
10 Close the computer cabinet. Do not reconnect the power cord
yet.
If you are also connecting external SCSI devices, skip to the next
section, Connecting External SCSI
If you are not connecting external SCSI devices, complete the
installation by continuing with Step 11.
11 Reconnect the power cord, then turn on the computer.
12 Install the software driver for your operating system. See
Chapter 4, Installing Drivers
Power input connector
Devices.
for more information.
Installing SCSI Devices
Internal SCSI cable
Power supply
3-4